Pyro Industries API-1394PCI Bedienungsanleitung PDF herunterladen (Seite 110)

■ THE TOOLSETS

Color Correction Toolset (Xpress Pro Only)

The Color Correction toolset (shown in Figure 3.5) is intended for use when working

with the Color Correction effect. The interface expands into three monitors: The center

monitor is intended to view the current clip that is being corrected; the other two mon-

itors can be used to display before and after clips for comparison while correcting col-

ors or for viewing a scene with elements similar to the corrected clip for comparison.

Figure 3.5 Color Correction toolset

Below the three monitors is the correction control panel, which has a tab so that

you can correct using color wheels or sliding parameters. It’s all pretty intricate stuff to

have an entire toolset created for one effect, but color correction can get pretty elaborate.

Source/Record Editing Toolset

The Source/Record Editing toolset (shown in Figure 3.6) is my favorite one and is by

far the most commonly used. The display is set up so that it resembles a typical inter-

face, with a Source monitor on the left and a Record monitor on the right. You can load

your clips from bins and display them in the Source monitor. The clips can then be

marked and spliced or overwritten to the sequence in the Record monitor. Simple, huh?

I personally prefer Source/Record over Basic because it allows me to focus on

one source and one sequence. Although Basic lets me instantly view and manipulate

multiple sources, I find this method a bit overwhelming and occasionally lose track of

which clip I am accessing—especially when some of the clips look similar. Besides, it’s

the toolset that I learned on, and it emulates every other type of major editing system.

4440c03.qxd 11/6/05 9:36 AM Page 89

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 370 371

Keine Kommentare

Pyro Industries API-1394PCI Bedienungsanleitung Seite 110